Hunter-fan 44459 Manuel d'utilisateur télécharger pdf (Page 12)

PAGE 12

■

Remove the wallplate from your thermostat by pressing the

release tab on the bottom of the thermostat. (See Figure 2.)

■

Position wallplate on wall and pull existing wires through large

opening. Then level for appearance. Mark holes for plastic

anchors provided if your existing holes do not line up with

those on the Hunter wallplate.

■

Drill holes with 3/16” bit and gently tap anchors into the holes

until flush with wall.

■

Reposition wallplate to wall, pulling wires through large

opening. Insert mounting screws provided into wall anchor

and tighten. (See Figure 3.)

12-13

INSTALLATION

Mount Wallplate and Thermostat

NOTE: 5-wire Systems

If your thermostat has one wire marked R or RH (4-wire system), then leave the jumper wire between the RH and RC terminals on

the wallplate.

Otherwise, if you have separate RH and RC wires (5-wire system), then remove the jumper wire between the RH and RC terminals.

Figure 2

Y/Y1

Figure 3

B99A p1-19 2/7/03 9:58 AM Page 12

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 39 40

Pas de commentaire

Hunter-fan 44459 Manuel d'utilisateur Page 12