Hunter-fan 41818-01 Manuel d'utilisateur télécharger pdf (Page 8)

41818-01 • 03/12/09 • Hunter Fan Company

All wiring must be in accordance with national and local electrical

codes and ANSI/NFPA 70. If you are unfamiliar with wiring, use a

qualiﬁed electrician.

Wall switches are not included. Select an acceptable general-use switch

in accordance with national and local electrical codes.

4-1. Make sure the power to the outlet box and associated wall switch

location is still OFF.

To connect the wires, hold the bare metal leads together and place

a wire connector over them, then twist clockwise until tight.

CAUTION: Be sure no bare wire or wire strands are visible after

making connections.

Dual Switch Wiring:

• e bare or green ground wire (grounding) from the ceiling to

the green ground wire (grounding) from the ceiling plate and

the green ground wire (grounding) from the fan

• e white wire (grounded) from the ceiling to the white wire

(grounded) from the fan

• e black wire (ungrounded) from the ceiling to the black wire

(ungrounded) from the fan

• e black/white wire (ungrounded) from the ceiling to the

black/white wire (ungrounded) from the fan

Single Switch Wiring:

If you want to, you can control both fan and light with one switch.

To do so connect the wires as follows:

• e bare or green ground wire (grounding) from the ceiling to

the green ground wire (grounding) from the ceiling plate and

the green ground wire (grounding) from the fan

• e white wire (grounded) from the ceiling to the white wire

(grounded) from the fan

• e black wire (ungrounded) from the ceiling to the black and

the black/white wire (ungrounded) from the fan

4-2. Push all wires and wire connectors back through the ceiling plate

hole into the outlet box.

Single Switch Wiring

Dual Switch Wiring

Wire

Connector

4 • Wiring the Fan

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15

Pas de commentaire

Hunter-fan 41818-01 Manuel d'utilisateur Page 8